1. Prep Your Garment
- Make sure it’s clean and flat.
- Pre-press for 10 seconds to remove moisture.
2. Cut Off Colour Strip
- Don’t forget to trim the coloured edge before pressing — or it will transfer onto the garment!
3. Place Your Transfer
- White side faces down onto the garment (design side touches the fabric).
- The clear film side faces up — you should be able to see the design through it.
- Use heat tape if needed.
4. First Press
- Temp: 150°C
- Time: 15 sec
- Pressure: Medium to Firm
- Cover with a Teflon sheet or baking paper.
5. PEELING (HOT PEEL)
Instant Hot Peel:
• Peel the film while it’s still hot, right after opening the press.
6. Second Press (Recommended)
- Cover again and press for another 15 sec to seal the print.
- For a pro finish, use a blank white canvas instead of Teflon — it helps remove excess glue.
Care Tips
- Wash inside out, cold wash only.
- No bleach or dryer.
- Hang dry for best results.
Storage Tips
- Keep transfers flat in a cool, dry, airtight spot.
- Avoid dust, moisture, or folding.
💡 For more hacks + detailed videos, visit: PressedtoImpressltd on tiktok